Have you ever tried to put a can of tuna behind your TV? You might be wondering why we have to do this, don’t worry, we’ll reveal it to you right now.
Unfortunately, the place where we decide to install the TV does not always have good reception but with this simple and economical trick we can see everything we want, optimizing the signal. Curious to know how to do it?
A little tip for watching TV well
What we are facing today is a problem that many people have in common, we are talking about the bad signal , which does not allow us to see all the channels we would like on television. In some cases these elements are only partially visible, in others they are completely hidden. Again, the signal can come and go.
Searching the web, we found a way to stabilize it and therefore enjoy a good experience. There is no need to spend money or hire a professional, the object we are going to use is in fact before our eyes on a daily basis and destined for the trash.

So we can recycle it and get significant benefits without absolutely damaging the device . Let’s see what this simple and quick method consists of.
Create a DIY antenna
You understood correctly, it is possible to create an antenna in just a few steps , taking advantage of the tutorial available on YouTube. The images are so complete that there is no need to give further explanations.
It really takes a few minutes and very little material, which can be found at any hardware or electronics store.
The first step is to take a can of tuna or any other food with a similar container and especially of the same material. Empty it and wash it carefully after removing the lid with the tab: the latter should not be thrown away but kept aside because we will need it soon.
During these first operations, it is important to be careful not to cut yourself. After having carefully washed and dried the box, we make a mark with a marker on the central point of the lower part and then we drill a hole .
Once we have the hole, we can take an adapter and insert it , then screw the nut into the part that comes out and tighten well.
Now let’s take a 10 centimeter antenna cable and cut both ends of the plastic sheath to reveal the internal filaments. One part must be connected to the adapter inserted in the center of the can , internally.
Now we take the remaining length of the antenna cable and screw the appropriate adapters and then connect the two ends respectively to the one inserted in the box (outside) and to the input which is usually behind the TV.
We finish with the last step, that is, we take the tab that we removed before and fix it inside the box, where the adapter will be with a piece of antenna cable. Once this is done, we will have our very original and economical DIY antenna and as you can see in the YouTube video, the TV receives the signal perfectly when connected, while it turns off when we unscrew the antenna from the box . Incredible! No expensive intervention and no effort.


